Symbol-technologies T350 User Manual download pdf (Page 10)

10

Cutting Attachment Shield Assembly

WARNING!

NEVER operate this machine

without the cutting attachment

shield. Operating without the cutting

attachment shield may result in seri-

ous injury.

(A) Cutting Attachment Shield

(1) Insert the cutting attachment

shield between the outer tube and the

lower clamp. Loosen the nut and bolt

which are tightening the lower clamp

if the cutting attachment shield does

not t with the lower clamp.

NOTE:

It may be necessary to loosen the lower

clamp bolt so that the shield will t

between the tube and clamp.

(2) Fit the two spacers (T350 only)

and the upper clamp over the outer

pipe and tighten with four bolts.

NOTE:

Tighten four bolts a crisscross fashion.

(3) Tighten the lower clamp bolt and

nut securely.

WARNING!

Carefully inspect the cutting

attachment shield assembly to

make sure it is tightened securely and

does not wobble.

(B) Shield Extension (when trimmer

head is in use)

(1) Attach the shield extension to the

cutting attachment shield.

CAUTION!

The line cutter is attached to the shield

extension and must be used when op-

erating with a trimmer head.

NOTE:

Make sure the shield extension is com-

pletely hooked at the hook receiver.

LOWER CLAMP

SPACER

SPACER

BOLT

NUT

BOLT

UPPER

CLAMP

OUTER TUBE

CUTTING

ATTACHMENT

SHIELD

CUTTING ATTACHMENT SHIELD

SHIELD EXTENTION

HOOK

HOOK

RECEIVER

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Comments to this Manuals

No comments