Symbol-technologies T350 User Manual download pdf (Page 12)

Mixing Fuel

Filling The Fuel Tank

1. Place the unit on a ﬂat, level surface,

and wipe any debris from around the

fuel cap.

2. Remove the fuel cap.

3. Fill the tank with clean, fresh fuel.

4. Replace the cap, and wipe away any

spilled fuel before starting the engine.

WARNING!

Minimize the risk of re,

burns, and personal injury!

 STOP engine before refueling.

 ALWAYS allow the engine to cool

before refueling

 ALWAYS open the fuel cap slowly

to allow any pressure build-up

in the tank to release fuel vapor

slowly.

 ALWAYS transport and store fuels

in an approved container.

 Avoid overlling and wipe-up all

spilled fuel. Move the engine at

least 3 meters from the fueling

point, storage area, and other

readily ammable materials before

restarting.

 ALWAYS inspect the unit for fuel

leaks before each use. During

each rell, make sure there are no

fuel leaks around the fuel cap and/

or tank. If a fuel leak is evident,

stop using the unit immediately.

Fuel leaks must be repaired before

using the unit.

 NEVER smoke or light any res

near the engine or fuel source.

 NEVER place any ammable ma-

terial near the engine or mufer.

 NEVER operate the engine without

the mufer in good working condi-

tion.

ALWAYS move the unit to a place

well away from a fuel storage area

or other readily ammable materi-

als before starting the engine.

IMPORTANT!

Mix only enough fuel for your immediate

needs! If fuel must be stored longer than

30-days, it should rst be treated with a

stabilizer such as StaBil™ or equivalent

product!

CAUTION!

Some gasolines contain alcohol as

an oxygenate! Oxygenated fuels may

cause increased operating tem-

peratures. Under certain conditions,

alcohol-based fuels may also reduce

the lubricating qualities of some mixing

oils. Never use any fuel containing

more than 10% alcohol by volume!

Generic oils and some outboard motor

oils may not be intended for use in

high-performance air cooled 2-cycle

engines, and should never be used in

your Shindaiwa engine!

CAUTION!

This engine is designed to operate on

a 50:1 mixture consisting of unleaded

gasoline and a premium 2-cycle mixing

oil only. Use of Non-approved mixing

oils can lead to excessive maintenance

costs and/or engine damage.

CAUTION!

Never attempt to mix fuel in the unit’s

fuel tank. Always mix all fuels in a

clean approved container.

 Use only fresh, clean unleaded gasoline

with a pump octane rating of 87 or

higher.

 Mixing fuel with a Premium 2-cycle

mixing oil designed for use with high-

performance 2-cycle air-cooled engines.

 Refer to the following examples of 50:1

fuel to oil mix quantaties:

Gasoline 2-cycle mixing oil

liters milliliters

2.5 l ................................................. 50 ml

5 l ................................ ...................100 ml

10 l .................................................200 ml

20 l .................................................400 ml

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Comments to this Manuals

No comments

Symbol-technologies T350 User Manual Page 12

Comments to this Manuals