Symbol-technologies T350 User Manual download pdf (Page 13)

13

WARNING!

MAKE SURE THE BLADE

IS WELL CLEAR OF ANY

INTERFERENCE. Before starting

the engine, place unit on clear, level

surface. Make sure you have good

secure footing and always keep a rm

grip on the machine. THE CUTTING

ATTACHMENT MAY ROTATE WHEN

THE ENGINE STARTS.

Starting the Engine

WARNING!

Move at least three meters

away from the fuel site before

starting the engine.

WARNING!

Never operate the engine

without the cutting attach-

ment installed.

Starting a Cold Engine and/or

Restarting After Refueling.

(a) Slide the ON-OFF switch to the “I”

position.

(b) Prime the engine by repeatedly de-

pressing the carburetor primer bulb

until fuel can be seen owing through

the transparent overow return tube:

(c) Push the choke lever upward

(“ closed“ position). (Cold engine.)

(d) Depressing the lock lever, pull the

throttle lever fully and depress the

throttle lock button. While depressing

the throttle lock button, release the

throttle lever and the lock lever. Now

the throttle stays at high idle (starting

speed).

(e) While rmly holding the outer tube

with one hand, pull the recoil starter

handle upward with your other hand.

Pull slowly at rst until you feel the

starter engage, then pull quickly

to start the engine. Do not pull the

starter rope to the end of its travel.

CAUTION!

Pulling the starter rope to the end

of its travel may damage the starter

mechanism.

IMPORTANT!

Repeated cranking of the engine with

the choke CLOSED (“ “) will lead to

engine ooding. If the engine fails to

start after several attempts, move the

choke lever to the OPEN position and

continue cranking.

(f) When the engine rst res, gradu-

ally return the choke to OPEN

(“ ”) position if you have not al-

ready done so.

• If the engine stops before the choke

is fully open, restart with the choke

closed.

• If the engine stops after the initial

ring, restart with choke closed.

(g) When the engine starts and is run-

ning, set the engine to idle by tap-

ping the throttle lever to release the

throttle lock.

WARNING!

Never start the engine from

the operating position.

Starting a Warm Engine

Starting a warm engine involves all of

the steps of starting a cold engine.

EXCEPT:

• The choke should be in the OPEN

position.

If the engine does not start, follow the

cold engine starting procedure.

When the engine starts:

• After the engine starts, disengage

the throttle lock and allow the engine

to warm-up at idle for 2 or 3 minutes

before operating the machine.

• After the engine is warm, pick up

the machine and clip-on the strap.

• Advancing the throttle makes the

cutting attachment rotate faster; re-

leasing the throttle makes the attach-

ment stop running. If the cutting at-

tachment continues to rotate, carbu-

retor idle speed should be adjusted.

(See next page.)

T350

C350/B450

OVERFLOW PIPE

Make sure the cutting

attachment is clear

of obstructions.

OVERFLOW TUBE

ON-OFF SWITCH

THROTTLE

LEVER

LOCK LEVER

THROTTLE LOCK

BUTTON

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Comments to this Manuals

No comments