Symbol-technologies T350 User Manual download pdf (Page 8)

8

Assembling the Outer Tube

NOTE:

Make sure that the throttle cable

is built into the cable guide of the

throttle lever.

(8) Shift the throttle lever back to original

position, pulling the ground wire and

throttle cable and tighten the screw

securely.

(9) Remove the bolt tightening the cylinder

cover.

(10) Put the bolt through the hole of the

ground wire terminal and tighten the

bolt.

Assembly of the Outer Tube

C350/B450

(4) Loosen the stopper bolt of the throttle

grip. Remove the stopper bolt and nut.

(5) Fully loosen the clamp bolt of the

throttle grip.

(6) Slip the right-side handlebar into the

throttle grip. Locate the throttle grip so

that the stopper bolt can pass through

the stopper hole.

Securely tighten the stopper bolt and

nut.

(7) Securely tighten the clamp bolt.

T350

(1) Loosen the 2 joint bolts fully.

JOINT BOLT

JOINT

GROUND WIRE

THROTTLE GRIP

(2) Slip the outer tube into the joint until

the tube bottoms. The outer tube or

gearcase shaft may have to be rotated

slightly for the splines on the mainshaft

to fully engage to the engine.

GROUND WIRE

(3) Attach the ground wire to the joint bolt.

(4) Tighten the 2 joint bolts securely.

(5) Loosen the screw which tightens the

throttle lever to the outer tube. Shift the

throttle lever toward the blade.

(6) Put the throttle cable into the tube.

Push throttle cable through hole in

rear grip.

(7) Set the throttle cable onto the

throttle lever. Use the wrench so

that the wire edge goes into the slot

of the throttle lever securely.

(1) Loosen the 2 joint bolts fully and slip

the outer tube into the joint until the

tube bottoms (up to the insert label).

The outer tube or gearcase shaft may

have to be rotated slightly for the splines

on the mainshaft to fully engage the

engine.

(2) Attach the ground wire to the joint bolt.

(3) Tighten the 2 joint bolts securely.

GROUND WIRE

JOINT BOLT

INSERT LABEL

SCREW

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comments to this Manuals

No comments