Symbol-technologies T350 User Manual download pdf (Page 9)

9

Assembly of the Handle

T350

WARNING!

NEVER operate this machine

without the front handle. Oper-

ating without the front handle may result

in serious injury.

NOTE:

Tighten four bolts diagonally to properly

secure the handle.

NOTE:

Adjust the handle at the best position for

operator comfort.

(1) Put four square nuts in the recess-

es on the underside of the barrier.

(2) Fit the handle and barrier over the

outer tube and tighten four bolts in a

crisscross fashion.

Throttle Cable Adjustment

(1) Pull the throttle trigger gently,

and check for free-play of

approximately 5mm.

(2) If free-play is out of specications:

(a) Slide the cable cap toward the

mufer side until the adjusting

nut and the lock nut appear.

(b) Loosen the lock nut slightly.

(c) Turn the adjusting nut so that

free-play is about 5mm.

(d) Then, tighten the lock nut.

(e) Slide the cable cap back.

(1) Loosen the two bolts of the lower

cap and remove the lower cap.

(2) Position the handle bracket

against the handle label located on

the outer tube.

(3) Attach the lower cap with the two

bolts and tighten the bolts. Make sure

the front handle is in position per the

illustration.

(4) Secure the cable to the outer pipe

with the two bands as the illustration

shows. The two bands are in the tool

bag.

BAND

HANDLEBAR

HANDLE BRACKET

HANDLE LABEL

LOWER CAP

BOLT

THROTTLE GRIP

Assembly of the Handle

C350/B450

LOCK NUT

ADJUSTING NUT

CABLE CAP

THROTTLE CABLE

OUTER TUBE

BARRIER

HANDLE

BOLT

NUT

BARRIER

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

No comments