Symbol-technologies T350 User Manual download pdf (Page 14)

14

Stopping the Engine

Idle the engine briey before stop-

ping, then slide the ON-OFF switch to

the “O” (for STOP) position.

WARNING!

The cutting attachment con-

tinues rotating for a while after

the switch is turned off.

WARNING!

The cutting attachment must

NEVER rotate at engine idle!

If the idle speed can not be adjusted

by the procedure described here, have

the unit inspected at an authorized

Shindaiwa dealer.

The engine must return to idle speed

whenever the throttle lever is re-

leased. Idle speed is adjustable, and

must be set low enough to permit the

engine clutch to disengage the cut-

ting attachment when the throttle is

released.

Engine Idle Adjustment

NOTE:

Carburetor fuel mixture adjustments

are preset at the factory on units with

emission control systems and cannot

be serviced in the eld.

(3) If a tachometer is available, the

engine idle speed should be adjusted

to 2,750 min

-1

(rpm)

(1) Place the unit on the ground, then

start the engine and allow it to idle

for 2-3 minutes until warm.

(2) If the attachment rotates when

the engine is at idle, reduce the idle

speed by turning the idle adjustment

screw counterclockwise.

To Wear the Strap

Shoulder Strap/Harness

(1) Attach the strap hook to the

hanger on the outer pipe.

(2) Wear the strap so that the hook

stays at your right side.

(3) Adjust the length of the strap so

that you can hold and operate the

machine comfortably.

(4) Make sure the hip pad stays be-

tween your hip and outer pipe. (B450

ONLY)

Emergency Release

In case of emergency, rmly pull the

white tab at the hook. The machine

will release from the strap.

T350

T350

C350/B450

T350

C350/B450

Idle Adjust

Screw

IMPORTANT!

Adjust the shoulder strap so the shoulder

pad rests comfortably on the off-side

shoulder and the cutting path of the cutting

attachements is parallel to the ground. Make

sure all hooks and adjustment devices are

secure.

WARNING!

Always wear a harness when

operating this unit with a blade.

NOTE:

Using a harness with a bruscutter allows you

to maintain proper control of the unit and

reduces fatigue during extended operation.

Double Shoulder Harness

Adjust the double shoulder harness straps

so the shoulder pads rest comfortably on

the offside of the shoulder and the cutting

path of the blade is parallel to the ground.

Make sure all hooks and adjusting devices

are secure.

C350

B450

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Comments to this Manuals

No comments