Symbol-technologies T350 User Manual download pdf (Page 15)

15

CAUTION!

To prevent possible engine damage,

do not allow the machine to run at high

speeds without a load. Avoid operating

the engine at low speeds. Doing so can

lead to rapid clutch wear. In addition,

slow-speed operation tends to cause

grass and debris to wrap around the

cutting attachment.

Operation

WARNING!

“BLADE THRUST” is a sudden

sideway or backward motion of

the machine. Such motion may

occur when the blade jams or catches

on an object such as a sapling tree or

tree stump. BE CONSTANTLY ALERT

FOR BLADE THRUST AND GUARD

AGAINST ITS EFFECTS.

WARNING!

Position the blade so cuts

are made between blade’s

8 o’clock and 10 o’clock

positions (as viewed from above).

DO NOT cut between the 11 o’clock

and 5 o’clock positions.

CAUTION!

DO NOT use 2-tooth blades with this

machine.

(1) After starting the engine, pull

the throttle lever gradually.

The engine speed increases

and the blade will start

rotating.

(2) When the throttle lever is

released, the engine goes

back to idle speed

automatically.

(3) Operate the machine at full

throttle while cutting. Best

fuel efciency is obtained by

releasing the throttle when

swinging back after cut.

(4) The blade rotates

counterclockwise. For best

performance and to minimize

being stuck by debris, move

the blade from right to left

while advancing on your

work.

WARNING!

NEVER strike or slam the

spinning blade against the

wood.

WARNING!

When transporting, make sure

the engine is not running and

blade is covered with blade cover.

Recommended

Cutting Attachments

Make sure to use the following rec-

ommended Shindaiwa cutting attach-

ment with this machine.

Blades

PART NUMBER 60903-98310

8-TOOTH BLADE

INNER BORE: 25.4mm

DIAMETER: 255.0mm

THICKNESS: 2.0mm

PART NUMBER 72430-92142

3-TOOTH BLADE

INNER BORE: 25.4mm

DIAMETER: 255.0mm

THICKNESS: 2.2mm

PART NUMBER 60903-98320

4-TOOTH BLADE

INNER BORE: 25.4mm

DIAMETER: 255.0mm

THICKNESS: 2.0mm

Trimmer Heads

(A) C350

PART NUMBER 78820-16000

TAP & FEED TRIMMER HEAD

BOLT DIAMETER: 10mm

THREAD: LEFT,1.25mm PITCH

(B) B450

PART NUMBER 78820-14000

SEMI-AUTOMATIC TRIMMER HEAD

BOLT DIAMETER: 10mm

THREAD: LEFT,1.25mm PITCH

(C) T350

PART NUMBER 78820-15000

TAP & FEED TRIMMER HEAD

BOLT DIAMETER: 8mm

THREAD: LEFT,1.25mm PITCH

Using A Blade

Direction of

Rotation

DO NOT

CUT

Ten

O'Clock

Eight

O'Clock

OK TO CUT

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Comments to this Manuals

No comments