Symbol-technologies MC50 User Manual Page 86
- Page / 102
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
MC50 User GuideGL-6
ESS_ID Extended Service Set Identifier, defines the coverage area. Prior to
the release of the 802.11 specification the ESS_ID was called the
Net_ID or Network Identifier. For mobile computers using
Spectrum24 radios with the 802.11 protocol, an ESS_ID allows
facilities to limit which Access Points a mobile computer can
communicate with. It is set on the Network tab of the Control Panel.
The mobile computer can only communicate with Spectrum24
Access Points that have matching ESS_IDs.
Ethernet Ethernet communication port. Allows a wired interface to a radio
network.
Flash Disk An additional megabyte of non-volatile memory for storing
application and configuration files.
Flash Memory Flash memory is nonvolatile, semi-permanent storage that can be
electronically erased in the circuit and reprogrammed. Series 9000
mobile computers use Flash memory to store the operating system
(ROM-DOS), the terminal emulators, and the Citrix ICA Client for
DOS.
File Transfer Protocol (FTP) A TCP/IP application protocol governing file transfer via network or
telephone lines. See TCP/IP.
Frequency Hopping The use of a random sequence of frequency channels to achieve
spread spectrum compliance. Stations that use frequency hopping
change their communications frequency at regular intervals. A
hopping sequence determines the pattern at which frequencies are
changed. Messages take place within a hop. See Hopping
Sequence and Spread Spectrum.
FTP See File Transfer Protocol.
Flash Memory Flash memory is responsible for storing the system firmware and is
non-volatile. If the system power is interrupted the data is not be
lost.
Gateway Address An IP address for a network gateway or router. A mobile computer
may be part of a subnet as specified by its IP address and Netmask.
It can send packets directly to any node on the same subnet. If the
destination node is on a different subnet, then the mobile computer
sends the packet to the gateway first. The gateway determines
how to route the packet to the destination subnet. This field is an
option used by networks that require gateways.
Hard Reset See Cold Boot.
Hopping Sequence A set of random frequencies designed to minimize interference
with other sets of random frequencies. A hopping sequence
determines the pattern with which a station that uses frequency
hopping changes its communications frequency. See Frequency
Hopping.
Hz Hertz; A unit of frequency equal to one cycle per second.
Host Computer A computer that serves other computers in a network, providing
such services as computation, database access, supervisory
programs and network control.
IDE Intelligent drive electronics. Refers to the solid-state hard drive
type.
- User Guide 1
- User Guide 3
- Revision History 5
- Contents 7
- Chapter 2. Operating the MC50 8
- Chapter 3. Accessories 8
- Tell Us What You Think 9
- MC50 User Guidevi 10
- About This Guide 11
- MC50 User Guideviii 12
- Introduction 13
- Service Information 14
- Configurations 14
- Chapter Descriptions 14
- Notational Conventions 14
- Related Documents 14
- Symbol Support Center 15
- Getting Started 17
- MC50 User Guide1-2 18
- Parts of the Mobile Computer 19
- Accessories 20
- Installing the Main Battery 21
- Using the Single-Slot Cradle 22
- Using the Four-Slot Cradle 23
- Using the CAM 24
- Calibrating the Battery 24
- Starting the Mobile Computer 25
- Figure 1-9. Today Screen 26
- Checking Battery Status 27
- Attaching the Handstrap 28
- Magnetic Stripe Reader 29
- Figure 1-14. Swiping a Card 30
- Getting Started 1-15 31
- MC50 User Guide1-16 32
- Operating the MC50 33
- MC50 User Guide2-2 34
- Using the Power Button 35
- Using the Stylus 35
- Using the Keypad 35
- Review Copy 36
- Special Character Key 39
- Key Mode Icon 41
- Figure 2-4. Orange Key Icons 42
- Shift Key Icon 42
- Figure 2-5. Shift Key Icons 42
- LED Indicators 43
- Beeper Indicator 44
- Data Capture 45
- MC50 User Guide2-14 46
- Linear Scanning 47
- Linear bar code 48
- PDF417 symbol 48
- View Finder 48
- (Aiming Pattern) 48
- 5. Release the scan button 49
- Resetting the Mobile Computer 50
- Infrared Communication 50
- Operating the MC50 2-19 51
- Receiving Information 52
- Operating the MC50 2-21 53
- MC50 User Guide2-22 54
- MC50 Integrator Guide3-2 56
- MC50 Integrator Guide3-4 58
- Single Slot USB Cradle 59
- Charging the Spare Battery 60
- Battery Charging Indicators 60
- Four Slot USB Cradle 61
- Spare Battery Charging 62
- Magnetic Stripe Reader (MSR) 63
- MC50 Integrator Guide3-10 64
- Cable Adapter Module 65
- Battery Charging 66
- USB Connection 66
- Accessories 3-13 67
- To Device 67
- USB Port 67
- Data Port 67
- Battery Insertion and Removal 68
- MC50 Integrator Guide3-16 70
- MC50 User’s Guide4-2 72
- Maintaining the MC50 73
- Troubleshooting 74
- Technologies 75
- MC50 User’s Guide4-6 76
- Technical Specifications 77
- MC50 User GuideA-2 78
- Glossary 81
- MC50 User GuideGL-14 94
- Numerics 95
- MC50 User GuideIndex-4 98
Related products and manuals for PDAs Symbol-technologies MC50
(44 pages)© 2020, manymanuals.com. All rights reserved. | 0.425 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals