Symbol-technologies MC70 User Manual download pdf (Page 55)

Using the MC70 2 - 23

Imager Scanning

1. Ensure that a scan-enabled application is loaded on the EDA.

2. Aim the scan window at the bar code.

Figure 2-18

Imager Scanning

3. Press the scan button. The red laser aiming pattern turns on to assist in aiming. Ensure the bar code is

within the area formed by the brackets in the aiming pattern. The Scan/Decode LED lights red to indicate

that scanning is in process, then lights green and a beep sounds, by default, to indicate the bar code was

decoded successfully. Note that when the EDA is in Pick List Mode, the imager does not decode the bar

code until the crosshair touches the bar code.

Figure 2-19

Imager Aiming Pattern: Bar Code Centered

Figure 2-20

Imager Aiming Pattern: Bar Code Not Centered

Linear bar code

PDF417 symbol

Symbol

View Finder

(Aiming Pattern)

Correct

Incorrect

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 165 166

No comments

Symbol-technologies MC70 User Manual Page 55